USER GUIDE - v1.0
ID: 5928937
28 |
OCTO – 71521
Visit the ENTTEC website for
the latest version
Cleaning
Dust and dirt build up can limit the ability for the OCTO to dissipate heat resulting in damage. It’s
important that the OCTO is cleaned in a schedule fit for the environment it is installed within to
ensure maximum product longevity.
Cleaning schedules will vary greatly depending on the operating environment. Generally, the more
extreme the environment, the shorter the interval between cleaning.
Before cleaning, power down your system and ensure a method is in place to stop the system
from becoming energized until cleaning is complete.
Do not use abrasive, corrosive, or solvent-based cleaning products on an OCTO.
Do not spray OCTO’s or accessories. The OCTO is an IP20 product.
To clean an ENTTEC OCTO, use low-pressure compressed air to remove dust, dirt and loose particles.
If deemed necessary, wipe the OCTO with a damp microfiber cloth.
A selection of environmental factors that may increase the need for frequent cleaning include:
o Use of stage fog, smoke or atmospheric devices.
o High airflow rates (i.e., in close proximity to air conditioning vents).
o High pollution levels or cigarette smoke.
o Airborne dust (from building work, the natural environment or pyrotechnic effects).
If any of these factors are present, inspect all elements of the system soon after installation to see
whether cleaning is necessary, then check again at frequent intervals. This procedure will allow you
to determine a reliable cleaning schedule for your installation.
To Next Page
Loading...
Need help?
General
