USER GUIDE - v1.0
ID: 5928937
18 |
OCTO – 71521
Visit the ENTTEC website for
the latest version
Creating a standalone effect
A standalone show can only be created when Standalone mode is activated. Follow the steps
below to create a standalone (effect):
1. Select the next available standalone slot and click on the Create button
2. Select an output to preview the standalone show on by using the check boxes
3. If the effect previewed is to be preserved, Type in a name and click on Save Effect button
Preview standalone effects
OCTO allows the preview of the standalone. Select the output to preview the standalone as
shown in the previous image.
If two different colour orders e.g.: RGB on output 1 and WWA in output 2 are assigned you can
only preview the effect on one output at a time. If you attempt to preview both outputs the
following message is displayed.
Standalone effects name
Up to 65 characters can be used for a standalone name. All characters are supported except
comma (,). The OCTO does not allow a standalone to be saved with an existing name on the
list.
To Next Page
Loading...
Need help?
General
