Enttec OCTO User Manual


USER GUIDE - v1.0
ID: 5928937
25 |
OCTO – 71521
Visit the ENTTEC website for
the latest version
Reset to factory defaults
Factory resetting the OCTO results in the following:
 Resets the device name.
 Enables DHCP.
 Static IP Address reset (IP address = 10.(octet1).(octet2).(octet3) where the three bytes
are the last three bytes of the mac address in decimal)
 Resets the gateway IP.
 Netmask is set to 255.0.0.0
 Restores standalone shows to factory default.
 Direct mode is activated
 Input protocol is set to Art-Net.
 LED protocol is set as WS2812B.
 Pixel color is set to RGB.
 Both ports are set to output 4 universes. The start universe for output 1 is set as 0 and
output 2 as 4
 Mapped pixels value is set to 680 pixels
 DMX start address is set to 0
 APA-102 global intensity set to maximum.
Using web interface
The reset to defaults command can be found under the Settings tab of the OCTO.
Once the command is pressed, a pop-up would appear as shown in the image below:
Using the reset button
The reset button restores the network configuration of the OCTO to factory defaults:
 To reset to factory defaults, the following procedure must be performed:
 Power off the unit
 Press and hold the Reset button.
 While holding the Reset button, power up the unit, and keep holding the button for 3
seconds.
 Release the Reset button once the status led starts blinking red.

Enttec OCTO Specifications

General

Brand	Enttec
Model	OCTO
Category	Controller
Language	English