USER GUIDE - v1.0
ID: 5928937
21 |
OCTO – 71521
Visit the ENTTEC website for
the latest version
Editing a standalone effect
The OCTO allows the editing of any saved standalone effect.
Follow the steps below to edit a standalone:
1. Select the standalone to be edited and click on the Edit button.
2. Select an output to preview the standalone on by using the check boxes.
4. Edit the standalone
5. If the standalone previewed is to be preserved, click on Save Effect button
Deleting a standalone effect
Select the standalone to be deleted and press on the Delete button.
The standalone selected for each output will continue to play unless it is deleted; in this case, the
standalone directly above will be enabled at the output, which had the deleted show. If there is no
standalone above, no standalone will be output.
If a slot without a standalone is deleted the following message is displayed:
To Next Page
Loading...
Need help?
General
