19
GB
Preset parameters
Finnish sauna mode
After switching on, the display alternates
between showing the current time and the
remaining heating time.
Heating time
The factory has limited the heating time to 6
hours. This means that the unit switches off
after 6 hours due to safety reasons.
The display alternates between showing the
current time and the remaining heating time.
20:03
05:58
05:58
Temperature display
During the heating phase plus approx. 15 min-
utes, the thermometer symbol continues to fi ll.
The control phase begins once the end tem-
perature is reached. The thermometer fi lling
now continually shows the temperature on
the sensor.
Heating phase Control phase
90
Actual - target display
By pressing the
"Auf
"
button for more than
3 seconds, you can show the actual tempera-
ture on the heater.
If a bench sensor is installed, you can show
the temperature at bench level by pressing
the
"Ab
"
button for more than 3 seconds.
To Next Page
