EOS 94 00 Series - User Manual

92 pages

To Next Page

Druck-Nr.: 2902 5162

Stand: 17.2021

Made in Germany

EOS Compact DC/HC

Control Unit for Sauna Cabins

Installation and Operating Instructions

Main Page

Documentation2
Table of Contents3
General Safety Instructions6
Safety Levels6
Mounting and Electrical Installation6
Operator Instruction9
Standards and Regulations11
Identification12
Scope of Delivery12
Nameplate13
Sensors13
Technical Data14
Accessories16
Intended Use17
Installation18
Routing the Lines18
Installation Site19
Mounting the Control Unit22
Mounting the Heater Sensor30
Mounting the Multisensor (Optional34
Mounting the Bench Sensor (Optional36
Mounting the Cabin Lighting36
Mounting the Fan37
Connecting the Lines38
Circuit Board Assignment for EOS Compact HC40
Circuit Board Assignment for EOS Compact DC41
Connecting the Sensor Cables42
Connecting Optional Modules44
Connecting the Consumer Lines45
Potential-Free Contact53
Checking for Proper Installation of the Vaporiser54
Commissioning55
Setup55
Defining the Light Source57
PFC Function58
Fan Function59
Operation61
Controls61
Rocker Switch (On, Off, Light Only61
Buttons and Screen62
Screen Saver and Sleep Mode62
Instructions for Operation63
Main Menu64
Status Bar65
Keypad Lock66
Display Settings66
Time66
Display Brightness67
Setup/Reset67
Sauna Controls68
Switching the Sauna Heater On/Off68
Dimming or Switching the Light On/Off69
Selecting Finnish/Bi-O Mode70
Temperature70
Setting the Humidity for Bi-O Mode71
Heating Period - Auto Stop72
Timer73
Profiles75
HOT Mode (Intense Heating75
ECO Mode (Temperature Decrease76
6.7.11 Retrieving Temperature/Humidity Values76
6.7.12 Switching the PFC On/Off Manually77
6.7.13 Switching the Fan On/Off Manually77
Advanced Settings78
Runtime for ECO Mode78
Runtime for HOT Mode79
Modes - Holiday Cottage, Holiday Resort, Remote79
Temperature Control81
Remote Control82
Maintenance83
Cleaning83
Maintenance84
Display of Software and Serial Number84
Display of Connected Modules84
Display of Contact Information84
Troubleshooting85
Error Messages85
Malfunction87
General Terms and Conditions of Service88
10 Disposal91

Questions and Answers

J
john59Aug 8, 2025
What to do if the EOS Control Unit displays a water shortage warning?
- C
  Cheryl GibsonAug 8, 2025
  If the EOS Control Unit shows a water shortage warning, first refill the water. Consider installing an automatic filling system (FWA) if needed. Also, check the water supply and clean the filter at the water supply connector if necessary. If there is no water supply, the water inlet valve is clogged, blocked, or defective, clean the water inlet valve and ensure it functions correctly. Replace the valve if needed.