EN-30 Installation and Operating Instructions - EOS Compact DC/HC
EN Installation
4
Securely tighten the housing using the four mounting holes.
You can connect the lines after mounting the housing. See
4 Connecting the lines, EN-38.
3.4 Mounting the heater sensor
The heater sensor must be installed where expected temperatures are the
highest, meaning directly above the sauna heater. Proper installation is
necessary to ensure compliance with the temperature limits and to ensure
that there is only a very slight fluctuation in temperature in the areas of the
sauna cabin where there are reclining options.
Hardware + tools:
Heater sensor and connecting cables
Drill used to drill a hole in the cabin ceiling
Screwdriver
Taut wire, as needed
To Next Page
Loading...
Need help?
General
