EN-72 Installation and Operating Instructions - EOS Compact DC/HC
EN Operation
All values that lie below or on the characteristic curve can be set and used.
When setting a parameter, e.g. temperature, the setting for the other
parameter (humidity) is automatically adjusted.
Values that lie above the characteristic curve cannot be set.
If no humidity sensors are used, the humidity is regulated in proportion to
time.
For example, the humidity setting = 40 means the vaporiser is on approx.
40 % of the total operating time.
This setting does not take into consideration the actual humidity in the
sauna cabin and makes it possible to consistently produce a specific vol-
ume of steam.
Setting the humidity
1 Choose the Humidity function.
2 Set the humidity with .
6.7.6 Heating period – auto stop
You can set a heating period for the sauna heater.
After switching on the system, the countdown for the heating period
appears in the status bar: .
The heating period can also be set in operation mode. The
heating period in progress is not altered by this. The new heating period
starts only after heating is switched on again.
The heating period cannot be set in the holiday resort or remote modes.
See: 6.8.3 Modes – holiday cottage, holiday resort, remote, EN-79.
0–100
To Next Page
Loading...
Need help?
General
