Epson 1200 series User Manual

7
Maintenance and Troubleshooting
7-21
R4C448
Rev. C
A5 size CHAP7.FM
2/11/00 Pass 3
R
Proof Sign-off:
tanto name SEI Y.Takasaki M.Fujimori
leader name M.Fujimori
editor name SEI M.Kauppi
Connection sequence is
incorrect.
Check the connection sequence and
make sure the scanner’s terminator
switch is set correctly. See Chapter 2
for details.
The Scanner Status does not indicate “Device Ready” after you
click Test in the EPSON TWAIN 4 dialog box or the Scanner’s
Properties dialog box (Windows 98) in the Control Panel.
Cause What to do
Interface cable is unsuitable. Make sure the interface cable meets
the requirements of your interface
board. See the manual that comes with
the interface board.
Connection is not made
properly.
Turn off the scanner and computer
and check the connection between the
scanner and computer.
SCSI interface board is not
installed properly.
Make sure the SCSI interface board is
installed correctly.
Power on sequence is
incorrect.
Turn off the scanner and computer.
Turn on the scanner and then turn on
the computer.
SCSI driver is not installed
correctly.
Make sure the SCSI driver is properly
installed.
SCSI ID number is
unsuitable.
Change the scanner’s SCSI ID number
to one that is not being used by any
other SCSI device.
Connection sequence is
incorrect.
Check the connection sequence and
make sure the scanner’s terminator
switch is set correctly. See Chapter 2
for details.

Epson 1200 series Specifications

General

Optical Resolution	1200 x 2400 dpi
Scanner Type	Flatbed
Maximum Resolution	9600 x 9600 dpi (interpolated)
Compatibility	Windows, Mac
Max Document Size	8.5" x 11.7" (216 x 297 mm)
Connectivity	USB
Color Depth	48-bit input, 24-bit output