Epson 1200 series - Installing Scanner Software for Windows

3
Installing the Software
3-5
R4C448
Rev. C
A5 size CHAP3.FM
2/11/00 Pass 3
R
Proof Sign-off:
tanto name SEI Y.Takasaki M.Fujimori
leader name M.Fujimori
editor name SEI M.Kauppi
Installing the Scanner Software for Windows
After connecting the scanner to your computer, install the scanner
software from the CD-ROM. The installation steps differ
depending on the version of Windows.
Find instructions for Windows 98 users in this section.
Instructions for Windows 95 and NT 4.0 users can be found in
“For Windows 95 and Windows NT 4.0 users” on page 3-15.
For Windows 98 users
The following will describe installing the software for SCSI users,
USB users should go to page 3-10.
SCSI users
Note:
If you are currently using Windows 95 and the scanner software is
already installed, but you are upgrading from Windows 95 to 98, first
uninstall EPSON TWAIN while running Windows 95. Then reinstall
EPSON TWAIN as described in step 1 below on Windows 98. When
uninstalling EPSON TWAIN see page 3-21 .
1. Make sure that the scanner is turned on.
2. Turn on the computer, and start Windows.