PS Data Format
Purpose:
To set the PS data communications protocol. To make any changes effective, turn off the printer and
then turn it back on.
Values:
Auto
*
Sets the PS data communications protocol automatically.
Standard Sets the PS data communications protocol to Standard.
BCP Sets the PS data communications protocol to BCP.
TBCP Sets the PS data communications protocol to TBCP.
*
Factory default menu setting
System Settings
Use the System Settings menu to configure a variety of printer features.
Power Saving Timer
Purpose:
To specify a time period before the printer enter each power saver mode.
Values:
Low Power
Timer
1min
*1
By default, the printer enters Low Power mode in one
minute of inactivity after completion of the last job.
You can change the Low Power Timer setting within
a range from 1 to 45 minutes.
1min - 45min
Sleep Timer
6min
*1
By default, the printer enters Sleep mode in six
minutes of inactivity starting from the moment it
entered Low Power mode. You can change the Sleep
Timer setting within a range from 6 to 11 minutes.
6min - 11min
AL-M200 Series User’s Guide
Using the Operator Panel Menus 150