Epson AL-M200 Series User Manual

Chapter 4
Printer Connection and Software Installation
Overview of Network Setup and Configuration
To set up and configure the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the System Settings page and keep it for referencing network settings.
4. Install the driver software on the computer from the Software Disc. For information on driver
installation, see the section in this chapter for the specific operating system you are using.
5. Configure the printer’s TCP/IP address, which is required to identify the printer on the network.
❏ Microsoft Windows operating systems: Run the installer on the Software Disc to
automatically set the printer’s Internet Protocol (IP) address if you connect the printer to an
established TCP/IP network. You can also manually set the printer’s IP address on the
operator panel.
❏ Mac OS X and Linux systems: Manually set the printer’s TCP/IP address on the operator
panel. To use a wireless connection (AL-M200DW only), also configure wireless network
settings on the operator panel.
6. Print the System Settings page to verify the new settings.
Note:
The reports and lists are all printed in English.
See Also:
“Printing the System Settings Page” on page 137
Connecting Your Printer
The interface cables of your printer must meet the following requirements:
AL-M200 Series User’s Guide
Printer Connection and Software Installation 25

Epson AL-M200 Series Specifications

General

Print Technology	Laser
Max Resolution	1200 x 1200 dpi
Monthly Duty Cycle	20, 000 pages
Warm-up time	15 seconds
Paper Capacity	250 sheets
Connectivity	USB 2.0, Ethernet
Paper Input	250-sheet
Supported Paper Sizes	A4, A5, A6, B5, Letter, Legal
Duplex Printing	Yes (Automatic)