Using Multiple Projectors
162
• If the remote control is listed as Off, you cannot operate the projector
from the remote control. Repeat the steps above to enable the remote
control.
a
• When you select 0 on the remote control, you can operate all
projectors regardless the Projector ID setting.
• You must select the projector ID from the remote control each
time you turn on the projector you have set it to control. When
you turn on the projector, 0 is selected as the remote control's
projector ID.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
Adjusting Color Uniformity
If the color tone on the projected screen is uneven in each projector, adjust
the color tone balance using each projector's Extended menu.
a
• The color tone may not be uniform even after performing color
uniformity.
• When the Color Mode is set to Dynamic, this function is disabled.
s Image > Color Mode
a
Press the [Menu] button, select the Extended menu, and press [Enter].
b
Select Multi-Projection and press [Enter].
To Next Page
Loading...
Need help?
General
