Epson EB-1470Ui - Whiteboard Settings Menu - Directory Menu

Projector Setup Settings - Extended Menu
228
s Extended > Whiteboard Settings > Mail
Setting Options Description
From Up to 64
alphanumeric
characters
(do not use " ( ) , : ;
< > [ \ ] : spaces)
Enter the email address to be displayed
to the sender.
Default e-mail
address
Up to 64
alphanumeric
characters
(do not use " ( ) , : ;
< > [ \ ] : spaces)
Enter the default email address used to
send emails. You can also specify the
domain name following an at mark to aid
email address input; for example,
"@xxx.co.jp".
Disallow Address
Input
On
Off
Set to On to choose e-mail addresses
only from an address book or directory
service.
Mail Server Configures your mail server.
Setting Options Description
SMTP Server SMTP Server: enter the IP address or
FQDN (Fully Qualified Domain Name)
for the mail server. You can enter up to
63 alphanumeric characters (you cannot
use " * + , : ; < = > ? [ \ ] ` | and spaces).
You cannot use the following IP
addresses: 127.x.x.x, 192.0.2.x, or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). If
you specify an FQDN, you must
configure a DNS server.
Authentication Authentication: sets the type of
authentication expected by the mail
server.
Port Number Port Number: The default port varies
depending on the Authentication
setting: 25 for Open, 465 for SSL, and
587 for TLS.
User name User name: enter a user name for the
mail server. You can enter up to 64
alphanumeric characters (you cannot
use : and spaces).
Password Password: enter a password for the mail
server. You can enter up to 64
alphanumeric characters (you cannot
use : and spaces).
Send a test e-mail Send a test e-mail: connects to the
SMTP server and sends a test email to
the address you set as the default.
Whiteboard Settings Menu - Directory Menu
Settings on the Directory menu let you select the directory service settings.