Epson EB-1470Ui - Page 229

Projector Setup Settings - Extended Menu
229
s Extended > Whiteboard Settings > Directory
Setting Options Description
Enable Directory
Access
On
Off
Set to On to search for user names and
email addresses from a directory service.
Search Base DN Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify the DN (Distinguished Name)
where the search for user names and
email addresses should start. Make sure
you specify all OU (Organizational Unit)
and DC (Domain Component) as
necessary in the order of OU then DC;
for example,
"OU=accounts,DC=example,DC=com".
The DN must be at or below the DC level
in the database structure.
Search target
attributes
Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify the search key for user name,
email address, and user group name. The
default value is "cn". You can specify up
to three keys separated by comma(s). Do
not use three or more commas, commas
right at the start or the end, and
continuous commas. The search is
performed using forward matching.
Setting Options Description
User Attributes Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify the attribute for user name; for
example, "cn".
Mail Attributes Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify the attribute for mail address; for
example, "mail".
Group Attributes Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify the attribute for a user group
name.
Additional filter Up to 63
alphanumeric
characters
(do not use : and
spaces)
Specify an additional search filter to
Search target attributes.
Directory Server
Settings
Configures your directory server.
LDAP Server LDAP Server: enter the IP address or
FQDN (Fully Qualified Domain Name)
for the LDAP server. You can enter up to
63 alphanumeric characters (you cannot
use " * + , : ; < = > ? [ \ ] ` | and spaces).
You cannot use the following IP
addresses: 127.x.x.x, 192.9.2.x, or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). If
you specify an FQDN, you must
configure a DNS server.
Port Number Port Number: enter a port number for
the LDAP server. The default port is 389.
Specify "3268" to search the global
catalog.