Selecting an Image Source
68
When multiple image sources are connected to the projector, such as a
computer and DVD player, you can switch from one image source to the
other.
a
Make sure the connected image source you want to use is turned on.
b
For video image sources, insert a DVD or other video media and press
play.
c
Do one of the following:
• Press the [Source Search] button on the control panel, remote
control, or control pad until you see the image from the source you
want.
a
This screen is displayed when no image signal is detected.
Check the cable connections between the projector and image
source.
• Press the button for the source you want on the remote control. If
there is more than one port for that source, press the button again to
cycle through the sources.
A
HDMI and MHL sources (HDMI1/MHL and HDMI2 ports)
B
Computer port source (Computer port)
C
Network source (LAN and Screen Mirroring)
D
Whiteboard source (toggles between whiteboard mode and the
previous input source)
To Next Page
Loading...
