Preparing
21
Connecting smartphones or tablets (EH-TW9200W/EH-TW8200W only)
You can connect MHL compatible smartphones or tablets to the WirelessHD Transmitter.
Use an MHL compatible cable to connect the micro USB port of smartphones and tablets to the HDMI5 port
on the WirelessHD Transmitter.
You can operate smartphones or tablets from the projector re‐
mote control.
You can also view video and listen to music while charging a
smartphone or tablet.
Attention
•
Be sure to use an MHL compatible cable for making connections. During charging, the smartphone or tablet
could generate heat, cause a liquid leak, explode or generate other conditions that could result in a fire.
•
When a connection is made using an MHL-HDMI conversion adapter, it may not be possible to charge or
control the device from the remote control.
c
Some devices use more power during video playback than what is supplied and will therefore not
enable charging during video playback or other operations.
Removing the Interface Cover
The interface cover is attached to the connector section on the rear of EH-TW9200W/EH-TW8200W. Remove
this cover when using a cable to connect a device.
There are gaps at the bottom of the interface cover that allows you to pull the cover forward and lift it from
the grooves at the top.
c
•
When reattaching, first insert the protruding sections into the grooves at the top.
•
Make sure you store the interface cover safely, as you need this when transporting the projector.
To Next Page
Loading...
Need help?
General
