3. Lift up the document guide and insert your document, image,
or picture under the guide. Align your document with the
guides grid lines. Repeat this step for every document you
want to scan, placing one document next to another.
4. Close the cover and scan according to the directions in your
software manual.
You can also use the document guide according to the
directions below, which are helpful if you find that your
document slips or doesn’t stay aligned using the above
method. The method below requires tape.
1. Lay the grid document guide upside down on a flat surface,
the long hole will be to the left.
g-009
0
+0.2
+0.1
-0.1
-0.2
g-010
L
Ginger Rev.C
A5 size Chapter 2
97/07/23 Pass 2, DR
2-10
Scanner Basics
To Next Page
Loading...
