Wi-Fi Setup:
Set up or change wireless network settings. Choose the connection method from the following and then
follow the instructions on the LCD panel.
❏ Wi-Fi (Recommended)
❏ Wi- Fi D i re c t
Wired LAN Setup:
Set up or change a network connection that uses a LAN cable and router. When this is being used, Wi-
Fi connections are disabled.
Network Status:
Displays or prints the current network settings.
Connection Check:
Checks the current network connection and prints a report. If there are any problems with the
connection, see the report to solve the problem.
Advanced:
Make the following detailed settings.
❏ Device Name
❏ TCP/IP
❏ Proxy Server
❏ IPv6 Address
❏ Link Speed & Duplex
Related Information
& “Making Wi-Fi Settings Manually” on page 26
& “Making Wi-Fi Settings by Push Button Setup (WPS)” on page 27
& “Making Wi-Fi Settings by PIN Code Setup (WPS)” on page 28
& “Making Wi-Fi Direct (Simple AP) Connection Settings” on page 29
& “Printing a Network Status Sheet” on page 39
&
“Checking the Network Connection Status” on page 31
&
“Changing the Network Connection to Ethernet from the Control Panel” on page 41
& “Making Advanced Network Settings” on page 30
Web Service Settings
Select the menus on the control panel as described below.
Settings > General Settings > Web Service Settings
Epson Connect Services:
Displays whether the printer is registered and connected to Epson Connect.
You can register to the service by tapping Register and follow the instructions.
User's Guide
Preparing the Printer
59
To Next Page
Loading...
