Commands Arranged by Topic
ESC U
Turn Unidirectional Mode On/Off
Format:
ASCII code:
ESC U n
Decimal:
27 85 n
Hexadecimal: 1B 55 n
Comments:
The following values can be used for n:
1: Turns the mode on
0: Turns the mode off
Printing is normally bidirectional. This command selects
unidirectional printing for more accurate positioning. This setting
can also be performed by SelecType.
ESC EM
Format:
ASCII code:
ESC EM n
Decimal:
27 25 n
Hexadecimal: 1B 19 n
Control Cut Sheet Feeder
Comments:
The following values can be used for n:
0: Turns mode off
4: Turns mode on
R: Ejects a sheet. (No paper is loaded.)
The command should not be used unless the cut sheet feeder is
installed. It is ignored if any value other than 0, 4, or R is used
for n.
The cut sheet feeder mode can also be turned on and off by
setting DIP switch 1-8.
9-10
Command Summary
To Next Page
Loading...
