Epson LQ-510 User Manual (English)

Other manuals for Epson LQ-510

User Manual295 pages

Paper Guide6 pages

Questions and Answers:

S
Susan ZimmermanAug 16, 2025
Why is my Epson Printer printing characters I didn't expect?
- D
  Daniel SmithAug 16, 2025
  If printed characters are not what you expected, the software may not be correctly installed for your printer. Use the program’s setup (or install) procedure to check the printer settings, and reset as needed. The wrong font may be selected. If your program accepts control codes, set the codes to the values below to select the built-in fonts: Roman: ESC k 0 Sans Serif: ESC k 1 Draft: ESC x 0. The wrong character table may be selected. If your application program is capable of sending control codes, specify the Epson Extended Graphics character table using ESC t l. You can also select the graphics character table by changing a DIP switch setting. To do this, turn off the power, set DIP switch 1-7 to on, then turn on the printer.
T
Troy ToddAug 20, 2025
Why is my Epson LQ-510 Printer print faint or uneven?
- W
  Willie BrooksAug 20, 2025
  If the printout is faint, or dots are missing in the printed characters or graphics, or a line of dots is missing in the printout, or dots are missing in random positions, the ribbon may be worn out. Install a new ribbon cartridge. The paper thickness lever may not be set correctly for the paper you are using, so set the paper thickness lever to match the thickness of your paper. There is either too much slack in the ribbon or the ribbon has come loose and gotten caught on something. Stop printing, turn off the printer, and reinstall the ribbon cartridge.
T
Troy WilsonAug 28, 2025
How to troubleshoot if my Epson Printer isn't getting power?
- K
  kristinagonzalezAug 28, 2025
  If the POWER light does not go on, the power cable may be loose or not properly plugged into the electrical outlet. Turn off the printer and see that the power cable is properly plugged in to the electrical outlet. The power switch may be off, so turn on the switch. Power may not be supplied to the electrical outlet. Plug another electrical device into the outlet to determine whether the outlet is operating properly. If the electrical outlet is controlled by a switch, use an electrical outlet that is not controlled by an outside switch.
N
njamesSep 1, 2025
What to do if Epson Printer print position is not what I expected?
- T
  Tiffany HernandezSep 1, 2025
  If printing starts too high or too low on the page, or one line printing has taken up two lines, the loading position may be incorrect. Use micro-adjustment to adjust the loading position. If the problem persists, check the top margin set by your application software and adjust it. Auto line feed may be on, so turn off DIP switch 2-4. The margin setting may not be correct. Use your application program to change the margin.
C
Christopher WheelerSep 8, 2025
How to troubleshoot Epson LQ-510 issues when using an optional interface?
- A
  Annette WadeSep 8, 2025
  If the printer does not print or the printout is not what you expected when using an optional interface, the interface board may be loose or not properly connected. Check that the interface board is correctly inserted into the connector on the main board. You may be trying to use a cable with the wrong specification, so make sure that the cable matches the specifications of the interface. The DIP switches or jumpers on the interface board may be set wrong. See the interface manual for the correct settings. The interface settings on the computer may be wrong. See your computer manual for the correct settings. The computer and interface settings may not match; match the settings for each condition. Two cables may be installed on the printer; only one cable may be attached at any time.