Adjusting the Loading Position
Using Micro-adjustment
1.
Make sure that the printer is turned on and that either a single
sheet or continuous paper is ready to be loaded.
2.
Press the LOAD/EJECT button to feed paper to the loading
position. Then press the ON LINE button; the MULTI-PART light
begins to blink.
MULTI-
PART
Note:
You can
use the
FORM FEED
and
LINE FEED buttons for
micro-adjustment only while the MULTI-PART light is blinking.
3.
Press the FORM FEED button to feed the paper forward or the
LINE FEED button to feed the paper backward.
Note: When the paper reaches the factory-set loading
position, the printer beeps and micro-adjustment feeding
pauses for a moment before continuing. You can use this
factory setting as a reference point when adjusting the
printer’s loading position. When the paper reaches either the
minimum or maximum top margin, the printer beeps and the
paper stops moving.
Using the Printer
3-13
To Next Page
Loading...
