3. Squeeze the wire clips together until they lock in place on both
sides of the connector.
4. If your cable has a ground wire, connect it to the printer’s
ground connector as shown below.
5. Plug the other end of the cable into the computer. (If the cable
has a ground wire at the computer end, attach it to the ground
connector at the back of the computer.)
Now see Chapter 2 for instructions on installing and using the
printer driver.
A11
A12
1
R
Adonis Rev.C
A5 size Chapter 1
96/12/ 19 pass 5
Setting Up the Printer
1-11
To Next Page
Loading...
