7. Pull out the sheet guide extension until it is fully extended.
(If you do not plan to stack the printed sheets, you do not
need to perform this step.)
8. If you are printing on long paper, open the extension flap at
the center of the sheet guide by lifting up its left side.
9. Press the
Operate
button to turn on the printer.
You are now ready to load paper with your cut-sheet feeder as
described in the next section. To remove the cut-sheet feeder,
reverse the steps above.
A56
A57
5
R
Adonis Rev.C
A5 size Chapter 5
96/12/ 19 pass 5
Using Printer Options
5-5
To Next Page
Loading...
