7. Push back the paper set levers to clamp the paper against the
guide rollers.
8. Before printing, make sure the paper release lever is set to the
single-sheet position. Also set the paper thickness lever to the
correct position for the paper loaded in the cut-sheet feeder,
as described on page 3-6. In your printer driver software,
select your paper size from the Paper Size list, and select
Sheet Feeder Bin-1
from the Paper Source list.
If you are printing from a DOS application, select the bin
number using the
Te a r O f f / Bin
button on the control panel.
The cut-sheet feeder loads paper when you send data to the
printer. You can also load paper by pressing the
Load/Eject
button.
A64
L
Adonis Rev.C
A5 size Chapter 5
96/12/ 19 pass 5
5-10
Using Printer Options
To Next Page
Loading...
