1-14
Setting Up the Printer
4. Slide a sheet of paper down firmly between the edge guides
until it meets resistance. The printer loads the sheet
automatically and begins printing the self test.
5. To stop printing temporarily, press the PAUSE button.
6. To end the self test, make sure the printer is not printing. Press
LF/FF to eject the sheet; then turn off the printer.
Here is part of a typical self-test printout:
Note:
If the self test did not print satisfactorily, see Chapter 4,
“Troubleshooting.” If it prints correctly, proceed to the next section.
To Next Page
Loading...
