6
Setting Up Your Scanner
If you can’t turn the transportation lock easily, plug the scanner in; then, after a
minute, unplug the scanner and try again.
Always lock the scanner carriage before transporting it; otherwise, the
scanner may be damaged. Be sure the scanner lamp is in the home
position (toward the back of the scanner). To ensure this, always turn on,
then turn off the scanner using the
P Operate button before locking the
carriage.
Connect the Scanner to Your Computer
You can connect your scanner with SCSI or USB. See the sections below.
USB
If you are connecting to a PC, Microsoft
®
Windows
®
98 or Windows 2000 must be
preinstalled on your system.
1. Make sure the scanner is unplugged, and the computer and any USB devices
connected to your computer are turned off.
2. Locate the USB cable that came with your scanner.
home position
basics.book Page 6 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
