Auto Document Feeder
55
Using the Auto Document Feeder
Loading Paper into the Auto Document Feeder
Your ADF can automatically load up to 30 sheets of the following paper sizes (based
on a paper weight of 17 lbs and a stack thickness of 0.24 inch [6.0 mm] or less):
■ Letter: 8.5 × 11 inches (215.9 × 279.4 mm)
■ Legal: 8.5 × 14 inches (215.9 × 355.6 mm)
■ Checks: 3.3 × 5 inches (83 × 127 mm)
■ B5: 7.17
×
10.1 inches (182 × 257 mm)
■ A4: 8.27
×
11.69 inches (210 × 297 mm)
The width can range from 3.3 to 8.5 inches (85 to 216 mm) and the length can range
from 5 to 14 inches (127 to 356 mm).
Do not feed photographic sheets or valuable original artwork into the auto
document feeder as a misfeed may result in accidental wrinkling or
damage.
If you are scanning high-quality color or halftone documents, place the
documents directly on the document table.
Opening the auto document feeder or its cover while it is operating results
in an error, and paper feeding stops.
Check the following before feeding a document into the feeder:
■ Ink on the document is dry.
■ The document has no holes and is not ripped or wrinkled.
■ The document has no staples, paper clips, or other objects attached that might
damage the feeder mechanism.
■ The document has no folds closer than 0.2 inch (5 mm) from its edge.
■ The document is not a multipart form or bound.
■ The document has no rear carbon coating.
■ The document has no cut-out areas.
basics.book Page 55 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
