8
Setting Up Your Scanner
Connect the Scanner to Your Computer
Make sure the scanner, computer, and any SCSI devices connected to
your computer are turned off. The scanner is off when the
P Operate
button is out (not pushed down below the surface of the panel).
Attach your SCSI cable to the scanner. The scanner is self-terminated and must be the
last device in the chain.
Your scanner does not include a SCSI cable. The length of the SCSI cable
must not exceed 9.8 feet (3 meters). If you are connecting multiple SCSI
devices, the total length of the SCSI bus (cables) must not exceed
19.7 feet (6 meters); otherwise the system may not work properly.
Install the EPSON TWAIN Driver
The scanner comes with two CD-ROMs: one for Adobe
®
PhotoDeluxe
®
and the other
for your EPSON TWAIN driver, scanner software, bonus software, and electronic
documentation. If you have the EPSON Perfection 1640SU or the EPSON
Perfection 1640SU PHOTO, your scanner also includes a third CD-ROM with
Adobe Photoshop
®
5.0 LE.
If You’re Running Windows 98 or Windows 2000 . . .
You may be asked to insert your Windows operating system CD-ROM during the
scanner installation. Have your Windows CD-ROM handy, in case you need it.
The illustrations in this section show Windows 98 screens. The screens in
Windows 2000 look different, but the steps are almost identical; any
differences are noted in the instructions below.
basics.book Page 8 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
