12
Setting Up Your Scanner
10. Click Finish to exit the New Hardware Wizard.
11. Now you can install your scanner software and bonus software as described on
page 19.
If You’re Running Windows 95 . . .
You may be asked to insert your Windows operating system CD-ROM during the
scanner installation. Have your Windows CD-ROM handy, in case you need it.
1. Make sure your SCSI board and SCSI driver are installed and the scanner is
connected to your computer.
2. Turn on your scanner first, then turn on your computer. When you see the screen
below, click Next.
basics.book Page 12 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
