Setting Up Your Scanner
11
7. In Windows 2000, you see the following screen:
Click Yes to finish installing your TWAIN driver.
8. After the scanner software installation is complete, the
Screen Calibration utility automatically starts. You
must calibrate your screen and scanner to reproduce
images closely matching the originals.
In the following window, move the slider to the right
or left until the shades of the horizontal gray stripes
appear similar. View the screen from a short distance.
The gray stripes will not perfectly blend together;
however, try to make the two tones match as closely
as possible. For best print results from an EPSON
ink jet printer, select a setting of 1.8.
9. Click
OK
to register the calibration setting.
You don’t need to change the screen calibration again so long as you
continue to use the same monitor. If you need to recalibrate your screen
at a later time, see your electronic
Reference Guide
for instructions.
basics.book Page 11 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
