46
Transparency Unit
Installing the Transparency Unit
Follow the steps below to install the transparency unit on the scanner.
1. Make sure the scanner is turned off.
2. Remove the document cover from the scanner by opening it to an upright
position and lifting it straight up.
3. Make sure the document table glass is clean and dust free.
4. Place the transparency unit on the document table glass so that the hinges face the
rear of the scanner and it fits on the document table glass.
5. Connect the transparency unit connector (arrow faces up) to the scanner’s option
interface.
6. Turn on the transparency unit.
7. Turn on the scanner.
For information on loading transparencies and selecting driver settings, see “Loading
Transparencies,” below.
on/off switch
basics.book Page 46 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
