Auto Document Feeder
57
Loading Documents Manually
You can load documents manually even when the ADF is installed.
Lift the ADF and place the document on the document table. Place the document
mat over the document, as shown. Then lower the ADF and scan the document.
Make sure the ADF and its cover are closed before scanning. If you are scanning thick
material or documents more than 1.6 inches (4 cm) thick, leave the ADF in the
upright position. Cover any exposed areas of the document table glass.
Be sure to select Flatbed in the Document Source settings in EPSON TWAIN.
Opening the auto document feeder or its cover while it is operating results
in an option error and stops paper feeding.
When scanning thin documents, you may see an impression of the
underside of the auto document feeder in your scans. If so, remove the
auto document feeder and reinstall the document cover as described on
page 36.
basics.book Page 57 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
