54
Auto Document Feeder
Installing the Auto Document Feeder
1. Make sure your scanner is turned off.
2. If your scanner has a document cover, remove it from the scanner by opening it to
an upright position, and lifting it straight up.
3. Make sure the document table is clean and dust free.
4. Insert the hinges on the ADF into the
outer square holes at the back of the
scanner and close the ADF.
5. Attach the ADF’s connector (arrow faces
up) to the scanner’s option interface.
6. Attach the paper support to the ADF.
7. Turn on the scanner.
For information on loading paper in the ADF
and selecting driver settings, see “Selecting
Settings” on page 56.
basics.book Page 54 Thursday, August 31, 2000 10:08 AM
To Next Page
Loading...
