Epson Perfection4180 Photo

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 32
4.2 Disassembly Procedure
This section illustrates how to remove the main components of this product. Unless otherwise specified, the reassembly procedure is omitted here since the product can be reassembled
in the reverse order of the disassembly procedure. For the engagement of the main components, refer to the general exploded views in the Appendix.
The following flowchart shows the disassembling procedure step-by-step. When disassembling any unit, refer to the corresponding page number shown in the following figure.
Figure 4-2. Disassembly/Assembly Flowchart
Start
Removal of TPU Unit
(P.33)
Removal of TPU Inverter
Board (P.48)
Removal of Power Switch
(P.41)
Removal of Carriage Unit
(P.35)
Removal of Panel Board
(P.38)
Removal of Hinges
(P.51)
Removal of Housing Upper
(P.34)
Removal of Main Board
(P.39)
Removal of Driven Pulley, Driven Pulley
Spring and Driven Pulley Holder Assy (P.45)
Removal of CR Motor Unit, Motor Tension Belt
and CR Tension Belt (P.46)
Removal of Panel FFC
(P.43)