Epson Perfection4180 Photo

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 43
4.2.7 Removal of Panel FFC
1. Remove the Carriage Unit. (Refer to 4.2.3)
2. Remove the Main Board. (Refer to 4.2.5)
3. Remove the Power Cable Cover. (Refer to Step 5 in 4.2.6 Removal of Power Switch.)
4. Remove the two screws (CBP, M3x8: 1, CPFP, M3x8: 1) that are securing the Ground
Plate.
5. Remove a washer from the threaded screw hole, and remove the Ground Plate as
removing the two-sided tape.
Figure 4-22. Removal of Ground Plate
When reassembling the Ground Plate, fit the position of the bosses to
the positioning holes shown in the
Figure 4-22 .
M3X8
Tightening torque 6-8kgfcm
Double-faced
tape position
Housing Lower
Ground Plate
Panel FFC
Washer
Positioning holes
and Bosses
Positioning hole
and Bosse
M3X8
Tightening torque 6-8kgfcm