Epson Perfection4180 Photo

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 38
4.2.4 Removal of Panel Board
1. Remove the Carriage Unit. (Refer to 4.2.3)
2. Remove the grounding wire through the notch of the front shaft hole of the Carriage
Shaft, and then remove the Panel Board upward.
3. Remove the Panel FFC from the Panel Board, and remove the Panel Board.
Figure 4-14. Removal of Panel Board
When reassembling the Panel Board, give attention to the followings.
 Fit the position of the grounding wire to the positioning hole
shown in the Figure 4-14.
 Fit the position of the four notches of the Panel Board to the
two hooks of the HOUSING LOWER shown in the Figure 4-
14.
Step 2-2
Panel FFC Panel Board
Step 2-1
Positioning
hole
Grounding
wire
Notch of front
shaft hole
Notches and
Hooks (x2)
Notches and
Protrusions (x2)