Epson Perfection4180 Photo

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 46
4.2.9 Removal of CR Motor Unit, Motor Tension Belt
and CR Tension Belt
1. Remove the Carriage Unit. (Refer to 4.2.3)
2. Disconnect the CR Motor Connector from the Main Board. (Refer to Step 1 to Step 7 in
4.2.5 Removal of Main Board.)
3. Remove the Power Cable Cover. (Refer to Step 5 in 4.2.6 Removal of Power Switch.)
4. Remove the one screw (CBP, M3x8) that is securing the CR Motor Unit, and remove
the CR Motor Unit.
Figure 4-28. Removal of CR Motor Unit
When reinstalling the CR Motor Unit, hook the Harness on the Hooks
and route the Harness.
CR Motor Cable
Hooks
M3x8
Tightening torque 6-8kgfcm
CR Motor Unit