Epson Perfection4180 Photo - Page 47

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 47
5. Remove the one screw (CBS, M3x5) that is securing the Tensioner, and remove the
Pulley.
6. Remove the Motor Tension Belt and CR Tension Belt from the CR Motor Unit in this
order.
Figure 4-29. Removal of Motor Tension Belt and
CR Tension Belt
A D J U S T M E N T
R E Q U I R E D
When reinstalling the Tensioner, perform "Tensioner adjustment".
(Refer to 5.1.3.1 Motor Tension Belt tension adjustment.)
M3x5
Tightening torque 1.5±0.5kgfcm
CR Tension Belt
Motor Tension Belt
Pulley
Tensioner