Epson Perfection4180 Photo - Page 37

EPSON Perfection4180 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 37
6. Pull the portion A of the Driven Pulley Set to the rear, and remove the CR Tension
Belt.
7. Remove the Carriage Shaft from the Bushing at the rear of the Housing Lower, and
while supporting the Carriage Unit by hand, remove the Carriage Shaft from the
Bushing at the front of the Housing Lower.
8. Slide the Carriage shaft to remove it from the Carriage Unit.
9. Turn the Carriage Unit over and pick the portion B (shown in the
Figure 4-13 ) up to
release the catch, and then remove the Carriage Unit.
Figure 4-11. Removal of CR Tension Belt
Figure 4-12. Removal of Carriage Shaft
Figure 4-13. Removal of Carriage Unit
CR Tension Belt
Step 6
Portion A
Driven Pulley Set
Step 7
Step 8-2)
Step 8-1)
Rear side Bushing
Front side Bushing
Carriage Shaft Carriage Unit
CR Tension Belt
Stop Plate
Stop Plate
Portion B