Using Multi-Screen Display
34
Adjusting the Virtual Display
After starting EasyMP Network Projection, the setup of the virtual
displays varies between Windows and Macintosh. The procedures are
explained separately below.
q
Check the following points before starting EasyMP Network Projection
when connecting via Wireless LAN. If the following points are not set
correctly, Multi-screen display cannot be used.
• The SSID for the computer and each projector must be the same.
• The Wireless LAN system for the computer and each projector's Wireless
LAN card must be the same.
You can modify the SSID and Wireless LAN system for the projector from
the Network menu in the projector's Configuration menu.
Procedure
For Windows
A Select "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EasyMP Network Projection" to start EasyMP
Network Projection.
B Select the "Use multi-display" check box.
Display layout and Display properties are added at the bottom of
the screen.
To Next Page
Loading...
Need help?
General