Epson PowerLite 1915 Network Guide

Using Multi-Screen Display
39
B Click "Connect".
The image allocated to each projector is projected.
In a Windows environment, you cannot view the image being sent
to a virtual display on the computer. To adjust the image on the vir-
tual display, you must do so while viewing the projected image.
To perform mouse-based operations on the virtual display, move
the mouse pointer in the direction of the virtual display, such that
the pointer appears on the virtual display.
C To terminate multi-screen display, click "Disconnect" on the
toolbar.
q
• In a Windows environment, if the virtual display driver has been enabled
such that the mouse pointer can be moved outside the limits of the screen,
there may be occasions when you lose track of the location of the pointer.
When you are not using a virtual display, clear the check mark against the
virtual display under Add-Remove EPSON Virtual Display, so that the
mouse pointer cannot be moved outside the limits of the screen. To
subsequently use multi-display again, place a check mark against the
required display under Add-Remove EPSON Virtual Display.
To clear a check mark, see the following.s p.33
• You can adjust each projector's color tone.s See your projector User’s
Guide.

Epson PowerLite 1915 Specifications

General

Brand	Epson
Model	PowerLite 1915
Category	Projector
Language	English