137
1
Managing Projectors
The EasyManagement software for your projector lets you monitor
and control your projectors from a remote computer:
■ Use EMP Monitor (available for Windows only) to see your
projectors’ status, switch image sources, and control basic settings.
■ Use the mail notification function to receive e-mail alerts about
possible problems.
■ Use a network management utility running SNMP, such as
HP OpenView, to manage your facility’s equipment from a
pre-existing system.
You can also use NS Connection to register up to 16 projectors as a
group. This allows you to provide quick and easy access to these
projectors from other computers.
To use the EasyManagement software to manage your projectors, first
install EMP Monitor as described on page 185. If you plan to create
projector groups, also install EMP NS Connection. Then connect and
configure each projector you want to monitor. You can connect the
projector wirelessly in Access Point mode (as described on page 68) or
over a wired network (as described on page 138).
This chapter covers the following information:
■ Connecting the projector to and configuring it for a wired
network
■ Monitoring and controlling your projector with EMP Monitor
■ Using e-mail alerts to warn you of problems
■ Understanding notification messages
■ Using a browser to monitor the projector
■ Using projector groups
note
If you’re using a network
management utility running
SNMP, you can configure
your network to send trap
alerts even without a plug-in
(see page 138). This feature
is intended for use by
network administrators
only.
To Next Page
Loading...
Need help?
General