Solving Problems 177
Solving EasyManagement Problems
You don’t see your projector in the EMP Monitor window.
■ Make sure that you’ve connected the projector to the network and
configured it correctly; see page 138 or page 62. Also, make sure
you’ve registered the projector with EMP Monitor; see page 139.
■ Make sure that Standby Mode in the projector’s Extended menu
is set to
Network ON.
■ If the computer you are using is running Windows XP or 2000,
you must be logged in as the Administrator.
■ Try restarting your computer.
You can’t connect to the projector using NS Connection.
■ Make sure you’ve installed the Epson 802.11g card correctly in
the projector; see page 60. If you have to reinstall the card, restart
NS Connection or the program will not be able to detect the
projector.
■ Restart your computer.
■ Make sure your projector and computer are configured correctly;
see page 62 (Ad Hoc mode) or page 68 (Access Point mode).
■ Make sure that you have sufficient wireless signal strength (above
50 percent). On a Macintosh, check the AirPort icon on the
Macintosh menu bar. In Windows, see the documentation for
your computer’s wireless card or adapter for details.
■ Make sure you aren’t projecting one of the EasyMP configuration
screens. (You should see a message that the projector is ready to
connect.) If you have to exit a configuration screen, restart
NS Connection.
■ If the projector is configured for Access Point mode and you’re
using DHCP, allow time for your projector to appear. It takes the
server a little while to pick up the IP address.
To Next Page
Loading...
Need help?
General