24 Displaying and Adjusting the Image
Adjusting the Image
Once you see your image, you need to make certain adjustments:
■ If the image is too high or too low, you can reposition it. See
below.
■ If you have quick setup enabled on the projector, see page 25.
■ To focus or zoom your image, see page 25.
■ If the image isn’t square, see page 26.
■ If a computer image displays incorrectly, see page 28.
If you need to fine-tune the image and/or sound, see page 117.
Adjusting the Height of Your Image
If the image is too low on the screen, you can use the front adjustable
foot to raise it.
1. Stand behind the projector. Press the blue foot release lever up
and lift the front of the projector.
2. Once the image is positioned where you want it, release the lever
to lock the foot in position.
3. If necessary, you can fine-tune the height or level the image by
turning the projector’s rear feet.
Raising the projector causes the image to distort or “keystone,” but
you can manually correct the shape as described in the next section.
Projector rear foot
To Next Page
Loading...
Need help?
General