Using the Remote Control 33
Replacing the Batteries
If the projector stops responding to the remote control, check the
following:
■ Make sure the remote control’s ON/OFF switch (shown on
page 32) is in the
ON position.
■ Press the light button and check to see if the buttons on the
remote control light up. (If you’re in a bright room, you may not
be able to see them light up.)
If the buttons do not light up, replace the batteries as described below:
1. Turn the remote control over.
2. Press down on the ridges at one
end of the battery cover as you
slide the cover off.
3. Install two AA batteries, inserting
the flat (negative) ends in first.
4. Slide the cover back in place.
caution
When replacing batteries,
take the following
precautions:
■ Replace the batteries as
soon as they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash immediately.
■ Do not expose batteries to
heat or flame.
■ Dispose of used batteries
according to local
regulations.
■ Remove the batteries if
you won’t be using the
projector for a long period of
time.
To Next Page
Loading...
Need help?
General