148 Managing Projectors
10. If you want to send e-mail alerts to other computers, enter
addresses for those computers in the
Destination address 2 and
Destination address 3 boxes.
11. Select the conditions under which an e-mail alert will be sent.
12. When you’re done, highlight the
OK button at the top of the
screen (you can either use the pointer button on the remote
control or press
Esc) and press Enter. Highlight the OK button
again and press
Enter to return to the main EasyMP Network
Screen.
For help understanding e-mail alerts, see the next section.
Understanding the Notification
Messages
If a projector experiences a problem, it sends an e-mail message to
each of the addresses you provided using EMP NetworkManager. The
message includes “Epson Projector” in the subject line.
The body of the message contains:
■ The name of the projector
■ The projector’s IP address
■ A description of the problem
The problem descriptions are similar to the errors reported by
EMP Monitor listed on page 144.
If a plus (+) sign appears, it indicates that a problem has occurred. A
minus (–) sign appears when the problem is resolved.
note
If a projector develops a
critical problem, it may not
be possible for it to report the
error.
To Next Page
Loading...
Need help?
General