Solving Problems 179
■ If you’re using Access Point mode and you’re connecting to the
wrong network, you may be experiencing signal interference from
another network. Try resetting your access point or base station,
then restart NS Connection.
■ If you’re using AirPort, the projector’s ESSID should match the
AirPort network name, not the name of the AirPort base station.
To check the network name, start the AirPort Admin utility,
select your base station, and click
Configure. Then click Show
All Settings
. The network name appears on the AirPort tab.
■ If you’re prompted for a password when you connect, enter the
WEP encryption key (if you’re using WEP encryption).
■ Try connecting using IP Connect Mode; see page 89.
An image displayed with EasyMP appears distorted.
Because of their resolution, some JPEG images cannot be displayed
correctly. Some JPEG files from digital cameras cannot be previewed.
Files with a high compression ratio may appear blurry.
In EMP SlideMaker 2, PowerPoint files don’t appear in the
file window.
EMP SlideMaker 2 does not support PowerPoint 95. Files created
in this version of PowerPoint must be opened and resaved in
PowerPoint 97 or later.
In EMP SlideMaker 2, your PowerPoint files don’t display
thumbnails and can’t be pasted into scenarios.
If you use PowerPoint 97, make sure the MS Office JPEG converter
has been installed. Run the Office 97 installer, display the
Converts
and Filters
option, and install the JPEG filter. Also, make sure
PowerPoint is installed on the computer you’re using to build the
scenario.
Your PowerPoint movie file does not play back.
Movies files inside a PowerPoint file cannot be played on the scenario.
To Next Page
Loading...
Need help?
General