Presenting Through a Wireless Network 63
2. To select Config, press the Enter button on the remote control.
You see the following screen:
Make sure
Easy connect mode is selected, as shown above.
If not, use the pointer button on the remote control to
highlight the checkbox next to
Easy connect mode, then press
Enter to select it.
3. Make sure the projector has a unique name, so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the
Projector name text box
then press
Enter. The outline of the text box turns yellow to
indicate you are in input mode. Press the pointer button up to
select individual letters in alphabetical order, or down to select
letters in reverse order; then press the pointer button to the
right to move to the next character position. When you’re done
typing the new name, press
Enter.
Easy connect
mode
note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.
If you want to enter
numbers, press the
Num
button on the remote
control. The button lights up
to indicate that the numeric
keypad mode is active. Press
the
Num button again to
exit numeric keypad mode.
To Next Page
Loading...
Need help?
General