Presenting Through a Wireless Network 69
You see the following screen:
Make sure
Access point mode is selected, as shown above. If
not, use the pointer button on the remote control to highlight
the checkbox next to
Access point mode, then press Enter
to select it.
4. Make sure the projector has a unique name so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the Projector Name text box
and press
Enter. The text box turns yellow to indicate you are in
input mode. Press the pointer button up to select individual
letters in alphabetical order, or down to select letters in reverse
order; then press the pointer button to the right to move to
the next character position. When you’re done typing the new
name, press
Enter.
Access point
mode
note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.
If you want to enter
numbers, press the
Num
button on the remote
control. The button lights up
to indicate that the numeric
keypad mode is active. Press
the
Num button again to
exit numeric keypad mode.
To Next Page
Loading...
Need help?
General